What do I do if one of my side panels are shaking/rattling when the fire is going?

Because of the panels being interchangeable and not permanently fixed to the fire there is a small chance that occasionally a panel may rattle slightly in its channel, this is due to the small gap between the coloured panel and the channel which allows the panel to move ever so slightly.

If this occurs then it can be remedied by removing the panel and putting a slight curve across the panel (you are only wanting to add a total of around 1mm - 2mm of curve) by flexing it from top to bottom. The easiest way to do this is to lie the panel half on a flat surface and apply weight to the bottom section on the surface and also to the top section hanging off the side. This will create a slight curve in the panel. Please note: You shouldn't bend it far enough to crease the panel or have any visible curve to it. This very small relief in the panel will mean that it sits tighter against both sides of the inside of the channel section and eliminates the rattle.