How do I refuel the fire?

Use the rake to evenly distribute the hot ember and ash along the base of the fire box, ensuring there is sufficient hot ember at the front to provide adequate ignition to the fresh fuel load. Load the fresh fuel so the logs are loaded lengthways and one end of each log is in contact with the back wall of the firebox. If you keep your fire burning under the metal air tubes which run along the top of the cylinder, this will ensure the maximum amount of heat is captured within the ceramic cylinder. As hot gases have the most distance to travel before entering the flue, this allows the whole fire to retain as much heat as possible. When raking, avoid plugging the Turboslide inlet with char or ash (this is the hole covered externally by the Turboslide below the door). Using other tools may cause damage to the ceramic cylinder, always take care not to impact the ceramic surface.